Symbols
(Blocks) - Architectural Millwork
We are in the process of creating a new Library of symbols for the
Architectural Millwork Libraries. The new library will contain over
200 Plan, Elevation and Section symbols of Tall Utility Cabinets in
heights of 60", 72" and 84" and in widths of 24"
to 48" in 1/4" increments.
Symbols
(Blocks) - Mechanical
We are also close to releasing the first of our Mechanical Symbols
Libraries - Angle Iron (157 symbols) and Channel (78 symbols).
Immediately following these libraries will be "T" shapes and
then Beams. We plan adding Steel Tubing very soon as well.
PeMillwork
Manager© Version 02.03
The PeMillwork Manager© will be upgradeable sometime in
September 2003. The upgrade will include the ability of the AutoCAD®
user to add blocks or libraries of his/her own, as well the addition
of the Tall Utility Cabinets Module mentioned above.
Block
Manager
At this time, a stand alone Block Manager, which we call the PeBlock
Manager©, is being created. It will be available with or
without our Quick Insert Blocks included with it. It will consist two
modules and will allow the AutoCAD® user to add blocks or
libraries of his/her own.
AutoLisp
Routines and Hatch Patterns
We hope to have several AutoLisp Routines and Hatch Patterns available
by the end of August 2003. Please check back often.
If
you have any comments, suggestions or complaints, please fill out our
Feedback Form to let us know. That is the main reason we redesigned
this site!
